top of page
IMG_8740_edited.jpg

Manual 
PUMP

ONE solution for the teaching Lab

We designed and 3D printed this pump with the classroom in mind. High quality filament and printing method results in a pump that can be reused multiple times. Let us know what you think: contact@petlfluidics.com

#1 Tip when using your pump:
GO SLOW!  About 1 full revolution every 10 seconds. Otherwise the pressure inside the channel is too high and the chip may delaminate.

#2 Tip when using your pump:
Insert the syringes and tubing first! Then load the liquid. The volume of the tubing is pretty significant, you need to load the tubing, not the syringe.

Screen Shot 2021-07-03 at 4.10.00 PM.png
bottom of page